Clean the Sensors on an Everest Printer
2001465_C
Rimage Corporation ©2010
Page 1
Notes:
•
Your system may not look exactly like the
system pictured.
•
The terms “Everest” and “printer” are
used throughout this document to refer to
the Everest III, Everest 600 and integrated
Everest 400 printer.
#
Required tools:
•
Can of compressed air
•
Rimage cleaning kit, Everest PN 3001252
Introduction
Use this procedure to clean a sensor on an Everest™ III, 600 or integrated 400 printer.
Rimage approved parts must be used for this process. The product warranty may become void if parts not
approved by Rimage are used; equipment or parts are tampered with, misused, neglected, or modified in any
respect without the written consent of Rimage.
When should you clean the sensors?
• You receive an error message stating that the printer is not detecting the print ribbon.
• You receive an error message stating that the upper sensor is not responding.
• You receive an error message stating that the lower sensor is not responding.
• The printing is off center.
Access the Sensors - Everest III and Everest 600
Note:
Refer to page 4 for instructions on accessing the sensors on the integrated Everest 400 printer.
1. Power off the
system
.
a.
Stop or pause
all jobs
.
b. Power off the
external/embedded control center/PC
.
c. Power off the
Everest printer
.
d. Disconnect the
power cord
from the back of the printer.
2. Open the
side cover
.
a. Press the two
side cover latches
to release the
side cover.
b. Lower the
side cover
.
Power Cord
Side Cover Latches
Side Cover
