100763_M
25
Maintain the Rimage 2000i
Replace the Ink Cartridges
Use the following procedure to change the ink cartridges in your Rimage 2000i.
-
Important!
You must use the appropriate ink cartridges in one of the configurations listed in the
Ink Requirements
section.
Refer to page 9.
1. Lift the
ink cartridge access door
. The ink cartridge carriage moves to an accessible position on the carriage guide.
2. When the ink cartridge carriage stops, lift the
ink cartridge latch
to the open position.
3. If an ink cartridge is already installed, slide the
ink cartridge
out of the ink cartridge cradle.
4. Remove a new
ink cartridge
from the packaging.
5. Carefully remove the
protective tape
that covers the ink nozzles.
-
Important!
Do not touch the nozzles or the copper contacts on the ink cartridges. If you touch these parts, clogs, ink
failure, and poor electrical connections are likely to occur. Do not remove the copper strips.
6. Hold the
ink cartridge
so that the copper strip is on the bottom, facing toward the printer.
7. Slide the
ink cartridge
into the cradle.
8. Push down on the
ink cartridge latch
until it snaps into place.
9. Close the
ink cartridge access door
. The ink cartridge status light flashes for a few seconds. When the status light stops
flashing, the Rimage 2000i is ready to print.
Note:
If the ink cartridge is not securely seated in the cradle, the printer will not recognize the ink cartridge. The
printer may not reset properly or you may receive an invalid ink cartridge message. If this happens:
•
Remove the
ink cartridge
and reinsert it. Be sure to press firmly when you reinsert it.
•
Make sure to use the appropriate ink cartridge. Acceptable cartridges are listed in the
Ink Requirements
section
on page 9.
•
If the problem persists, replace the
ink cartridge
.
10. Align the
ink cartridges
. Refer to
Align the Ink Cartridges
on page 18.
Ink Cartridge Latch
Ink Cartridge
E
ng
lis
h
E
ng
lis
h
