11
INSTALL THE TOOL HOLDER
Install the Tool Holder (P, #F5) onto the outside surface of either the left or
right Leg (H, #F1) with the two Washers and hex head mounting Screws
(P,#F6,7) provided. This holder includes multiple holes for convenient stor-
age of wrenches, centers, tool rests and other lathe accessories. Figure 8.
ASSEMBLY
INSTALL THE SLIDING BED HANDLE
Install the Handle (R, #C9) onto the right end of the sliding
bed with the two Hex Screws (#C10) provided. Figure 10.
NOTE:
INSTALLING THIS HANDLE IS OPTIONAL.
This handle is NOT to be used for moving or lifting the
lathe. If ever the sliding bed fails to work due to a motor or
mechanical issue, the motorized screw mechanism (#E17)
can be disengaged by removing the two end Cotter Pins
(#E12). Then the sliding bed will be free to be moved by
pulling or pushing with the end handle. See page 15.
FIG. 10
TAILSTOCK STORAGE
For additional storage of spur and live centers, the tailstock
features a small tool holder behind the front hinged door. It
will also hold the short knockout bar used to remove the spur
center’s removable point. Figure 9.
OPERATION
FIG. 11
A. TOOL REST BODY LOCK HANDLE:
This cam action
lever handle locks the tool rest body down in position on
the lathe bed. Unlock handle to position the tool rest in any
location along the lathe bed. Tighten the handle when the
tool rest is properly located for safe turning of the work-
piece. See page 17 for instructions on how to adjust the
locking tension.
B.
TOOL REST LOCK HANDLE:
Locks the tool rest in
position for supporting your tools during turning. Unlock the
handle to adjust the tool rest at a specific angle, or height.
Tighten handle when properly positioned.
NOTE:
The handle is spring loaded on its internal bolt. To
change the handle position, pull the handle out, rotate it to
the position you desire, then release the handle and it will
align itself back onto the bolt.
TOOL REST CONTROLS
- Figure 11
A
B
INSTALL THE TAILSTOCK HAND WHEEL
Install the Tailstock Hand Wheel (Q, #D8) onto the rear spindle
of the Shaft Assembly (Quill) (#D6). Secure with the 2 set screws
onto the 2 flat spindle areas with the 3mm Hex Wrench provided.
Figure 9 A.
FIG. 8
FIG. 9
A
