7
Fig. 06
Fig. 07
Fig. 05
Fig. 04
Installing the Vertical Supports
Locate the two vertical support bars, two M8X10MM
hex bolts and two 8MM washers.
1. Hold the vertical support bar upright over the hole
located at the corner of the base as shown
.
2. Place a washer onto a hex bolt and insert into
the bottom hole of the verticle support and into the
threaded hole in the base
(Fig. 04)
.
Mounting the Filtration Housing
Locate the filtration housing, six M6X10MM hex bolts,
six 6MM washers and the rubber gasket.
1. Align the holes of the mounting flange for the
filtration housing with the holes for the mounting
flange of the collector motor.
2. Place the rubber gasket between both mounting
flanges
(Fig. 05).
3. Secure the assembly with the six M6X10MM hex
bolts and six 6MM washers.
Installing the Handle and Spacer Blocks
Locate the handle, two spacer blocks, four M8X45MM
hex bolts, four 8MM hex nuts and eight 8MM washers.
1. Align the holes of the handle and spacer blocks
with mounting holes in the filtration housing.
2. Place the rubber gasket between both mounting
flanges
(Fig. 06).
3. Secure the assembly with the six M8X45MM hex
bolts and six 8MM washers.
Installing the Upper Bag Support
Locate the two M4X12MM hex bolts and two 4MM
washers.
Install the upper bag support to the side of the
filtration housing with hook pointing as shown
(A--Fig. 07)
.
Note:
If you purchased the optional canister this step can
be omitted. Insert washers and screws into the filtration
housing to fill unused holes.
Vertical
supports
Rubber gasket
Spacer block
Handle
Upper bag support
A
Summary of Contents for 60-100
Page 11: ...11 Troubleshooting Wiring Diagram ...
Page 13: ...13 Parts Explosion ...
Page 15: ...Notes ...