Rikon Power Tools 10-201, Operator'S Manual, Page: 12 / 40

12
RIVING KNIFE/SPLITTER COMPONENTS
ASSEMBLY
Note:
Remove the table insert (A) (Table insert is gripped
by four magnets on the table). SEE FIG. 21
Fig.21
INSTALLING THE RIVING KNIFE/SPLITTER
1. Loosen the knob (C), line up the riving knife/splitter in
the proper direction to the mounting bracket (B).
SEE FIG. 22
2. Push the Riving Knife/ all the way down into the
mounting bracket, make sure the location pin is
properly locked in the hole of the Riving Knife/
.
(The location hole is on the button side of the Riving
Knife/
).
3. Tighten the fasting knob (C).
1. Loosen the fasten knob (C). SEE FIG. 22
2. Remove the Riving Knife/ out of mounting
bracket.
Make sure blade or arbor is at the highest
position before adding or removing the Riving
Knife/
.
splitter
Splitter
Splitter
Splitter
Splitter
SEE FIG. 23
NOTE:
Fig.22
C
Fig.23
C
B
BLADE ASSEMBLY
Fig. 24
A
REMOVING THE RIVING KNIFE/SPLITTER