13
Blade Guard and Splitter Installation
1. Remove table insert and raise the saw blade,
then loosen the hex head cap screw (A, Fig.17)
located on the rear table trunnion assembly. Figure
17.
2. Install guard post through slot at rear of saw
and into the hole in the trunnion. Fasten into place
with one 8MM square nut (B, Fig.17) with 14MM
wrench. Figure 18.
3. The spillter support bracket must be installed on
to guard post as shown. Figure 19.
4. Slide the guard into place and tighten the hex
head cap screw on the rear trunnion assembly
and tighten the nut on the splitter support bracket.
Figure 20.
Figure 17
Figure 18
Figure 20
Assembly
A
B
Figure 19
Summary of Contents for 10-050
Page 19: ...19 Parts Diagram ...
Page 20: ...20 Parts Diagram ...
Page 22: ...22 Parts Diagram ...
Page 24: ...Parts Diagram 24 ...
