Riken Keiki 70D Series, Communication Function Manual

Page: 62 / 70

4. PLC Communication Functions 4-5. Command
- 59 -
4-5-4. Data relative to Basic Data: Large commands
Address Item Description
GD-70D-EA
Writing area
40
Command execution
status (GD-70D-EA) 0: Normal state
1: Processing in progress
41
Command execution
result
For Command 1 (setting alteration),
(Successful: bit ON Failed: bit OFF)
bit12: Sensitivity correction
bit11: Date and time
bit10: Zero follower
bit9: Zero suppression type
bit8: Zero suppression value
bit7: Alarm delay time
bit6: Fault alarm pattern
bit5: Gas alarm pattern
bit4: Second alarm setpoint
bit3: First alarm setpoint
bit2: Alarm type
bit1: Subnet mask
bit0: IP address
For Command 2 and so on
0: Failure
1: Success
Address Item Description
GD-70D-EA
Reading area
0 - 15 Various setting data
16
Command execution
status (PLC) 0: Normal state
1: Processing executed
17 Command Set command code.
18 Parameter
Depending on command (See the
command code table below)
Command codes for Basic Data: Large
Command code Details Parameter
1 Setting alteration Setting flag (see below)
2 Buzzer stop Unassigned
3 Inhibit on Unassigned
4 Inhibit off Unassigned
5 Enter the maintenance mode Unassigned
6 Exit maintenance mode Unassigned
7 Zero calibration executed Unassigned
8 Enter the alarm test mode Unassigned
9 Exit the alarm test mode Unassigned
10 Alarm test concentration setting Test concentration value