Installation
Guide
RIGOL
1
DP700 Rack Mount Kit
RM-3-DP700
This rack mount kit (RM-3-DP700) is designed to mount three
RIGOL
DP700 series
programmable linear DC power supplies into a 19-inch cabinet that conforms to the
Electronic Industries Association (EIA) standard.
Kit Part Checklist (RM-3-DP700)
No.
Name
Qty.
Description
1 Right
Fastener 1 --
2
Connecting Plate A
2
--
3
Connecting Plate B
2
--
4 Left
Fastener
1 --
5
M4 Screw
28
M4x8 Phillips Pan Head Screw
6
M4 Screw
8
M4x8 Phillips Countersunk Flat Head Screw
7 Rail
2 --
8 Bottom
Plate
1 --
9
Side Beam Fastener
4
--
10 Retaining
Bracket 4 --
11
M6 Screw
12
M6x16 Phillips Pan Head Screw
12
M6 Nut
12
M6 Square Lock Cage Nut
RIGOL
2
3
6
1
4
7
8
9
10
5
5 6 11 12
Installation
Guide
RIGOL
2
Installation Tool
The PH2 Philips screwdriver is recommended.
Space Requirements
To mount the instrument into the cabinet correctly, please ensure that the following
requirements are met:
The cabinet must be a standard 19-inch one.
The available height of the cabinet should be at least 4U.
The depth of the cabinet should be at least 500 mm.
The dimensions of the rack are as shown below.
Unit: mm
Installation Procedures
CAUTION
Only authorized operators are allowed to perform the installation. Improper
installation might cause damage to the instrument or an installation failure.
1.
Remove the four rubber protective covers located at the four corners of the front
panel and the four ones at the corners of the rear panel of the instrument
respectively.
2.
Attach two rails (with the U-channel
facing outward) to both sides of the
bottom plate, and then fasten them
with eight M4 pan head screws.
3.
Attach two side beam fasteners to
the front ends of each rail, as shown
in the figure below, and then secure
them with four M4 pan head screws.
