Rigid Industries HOOD MOUNT 46549 Installation Instructions Download Page 1

Page: 1 / 4

Can-am

maverick

2014-2016 can-am

maverick

kit includes

(1) Single-Piece Mount #46549
(3) 1/4-20 x 5/8” Hex Head Self Drilling Screw

HOOD MOUNT

Installation Instructions

Fits (1) 10" SR-Series

*Light sold separately

Thank you for purchasing Rigid Industries® products for your Can-Am®. Installation is fairly simple

with the right tools and good mechanical abilities. If you are not confident in your mechanical skills,

please seek the help of a professional to perform the installation. Please read through all of these

instructions and tips before proceeding with the installation.

It is strongly recommended that this product be installed by a professional.

Important

Always disconnect any power sources connected to your

vehicle before servicing fuses or electrical systems.

step 1

Draw a line on all three hood tabs, flush to

the hood brace (use the hood brace as a

guide) before removing the hood.

See Figure 1.

Figure 7.

Figure 1

Summary of Contents for HOOD MOUNT 46549

Page 1: ...es If you are not confident in your mechanical skills please seek the help of a professional to perform the installation Please read through all of these instructions and tips before proceeding with t...

Page 2: ...ng vent tubes on the square bar under the hood See Figure 3 step 2 Remove hood then tape off the three marked tabs Use tape as guide to cut tabs off Remove tabs See Figure 2 Figure 7 Figure 2 Figure 2...

Page 3: ...Industries mount with 3 1 4 20 X 5 8 Hex Head Self Drilling Screw See Figure 5 step 4 Center Rigid Industries mount and mark 3 1 8 holes to be drilled See Figure 4 Figure 7 Figure 4 Figure 4 1 Figure...

Page 4: ...liability company d b a Rigid Industries For warranty information visit www rigidindustries com about warranty WARRANTY INFORMATION Your installation is now complete Welcome to the Rigid Nation Wirin...