background image

2-

Unzip the carrier and place it on top of the vehicle with 

its non-zippered end facing front. 

3-

Load your gear within the shape of the carrier (Fig 1). 

Place sharp edged items in the middle and softer items 

around them. 

WARNING: DAMAGE MAY OCCUR TO THE CARRIER 

IF EXCESS MATERIAL FLAPS IN THE WIND. 

TO ELIMINATE EXCESS MATERIAL, PACK THE CARRI-

ER FULL. IF UNABLE TO PACK FULL, FILL THE FRONT 

CORNERS OF THE CARRIER AND PULL THE EXCESS 

MATERIAL DOWN OVER THE SIDES. HOLD THE  

EXCESS MATERIAL SECURELY IN PLACE WITH THE 

CARRIER’S STRAPS.

4-

Close the zipper as you fill the carrier from the front to 

the rear. 

1-

Remove the Car Clips from the (4) attachment straps (Fig 

3); the Car Clips will not be used.

3-

Attach each strap by wrapping it around the rack, 

threading its end through its loop, and pulling tight (Fig 5). 

4-

Thread the straps up through slot A and down through 

slot B of the buckles (Fig 6) and tighten the straps evenly.

Pack The Carrier

Attach The Carrier - WITH A Roof Rack

The correct attachment of this product is critical and 

beyond the control of Rightline Gear. The safe use 

and long life of this product depends entirely on 

your good judgment and following these directions.

Fig 1

Fig 2

2-

Decide if you will be attaching the straps to the roof 

rack side rails or cross bars. If side rails, the straps will 

connect to the side buckles (Fig 4). If cross bars, the straps 

will connect to the front and rear buckles (Fig 4).

Ace Car Top Carriers        100A30, 100A20, 100A50 

1-

Clean the vehicle’s roof of all dirt and debris. 

NOTE:  REQUIRES SPACE UNDER THE ROOF RACK 

SIDE RAILS OR CROSS BARS FOR THE CARRIER’S 

ATTACHMENT STRAPS TO PASS THROUGH.

Fig 6

5-

Tie off the strap ends so they don’t flap in the wind (Fig 

7). Make sure to re-tighten the straps after a few miles 

and check them regularly throughout the trip.

Fig 7

Hook-&-Loop Closures

Hook-&

-Loop

Closures

Protective Flap

Front

Fig 3

Fig 4

Fig 5

Side

Buckles

Rear

Buckles

Front

Buckles

Front

Side Rail

Side Rail

Cross

Bar

Cross

Bar

A

B

https://rightlinegear.com/support-

faqs/product-videos/

Set Up

Video:

5-

Fold the protective flap down to secure the hook-&-loop 

closures (Fig 1 and Fig 2). Make sure the hook-&-loop clo

-

sures on the zipper flap completely overlap those on the 

carrier. If it is difficult to secure the closures, the carrier is 

over packed.

NOTE: IF A STRAP MAKES NOISE WHILE DRIVING, 

LOOSEN THE STRAP, RE-POSITION IT SLIGHTLY, 

AND RE-TIGHTEN IT. 

Reviews: