9
10
8
10
12
11
11
DETAIL B
PRE-INSTALLED
T-SLOT PLATE IN
EACH COLUMN
DETAIL A
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 10/8/12
K&A MANUFACTURING
PAGE 2 OF 4
STEP 4:
PLACE THE LEFT HAND COLUMN ASSEMBLY
5
AND THE CENTER COLUMN ASSEMBLY
6
ON THE
WORKSURFACE
1
, ALIGNING THE HOLES IN THE WORKSURFACE SUPPORTS WITH THE PILOT HOLES IN THE
WORKSURFACE.
STEP 5:
INSERT (2) SOCKET SCREWS
11
INTO (2) STAR WASHERS
10
. INSERT THESE THROUGH THE CENTER HOLES
IN THE CROSS SUPPORT BRACKET
8
AND THREAD THEM INTO THE HOLES IN THE T-SLOT PLATE THAT IS PRE-
INSTALLED IN THE SLOT IN THE CENTER COLUMN ASSEMBLY
6
. SEE DETAIL A. TIGHTEN THEM JUST ENOUGH
SO THE BRACKET CAN MOVE UP AND DOWN ON THE COLUMN ASSEMBLY.
STEP 6:
WITH THE HELP OF AN ASSISTANT, INSERT (4) SOCKET SCREWS
11
INTO (4) STAR WASHERS
10
. INSERT
(2) OF THESE THROUGH THE HOLES IN THE RIGHT HAND END OF THE CROSS SUPPORT
9
. THREAD THEM INTO
THE HOLES IN THE SUPPORT BRACKET
8
AND FULLY TIGHTEN. INSERT THE OTHER (2) SOCKET SCREWS WITH
WASHERS THROUGH THE HOLES IN THE LEFT HAND END OF THE CROSS SUPPORT. THREAD THEM INTO THE HOLES
IN THE T-SLOT PLATE IN THE LEFT HAND COLUMN ASSEMBLY
5
. SEE DETAIL A. DO NOT FULLY TIGHTEN.
5
6
1
SUPPORT
WORKSURFACE
SEE DETAIL B
STEPS 4-7
