12
14
17
12
13
12
18
12
16
15
12
12
7
2
1
if required by turning the
leveling glides clockwise
(from the top) on the low
corners of the workstation.
If your workstation has
casters, level it by turning
the bolts at the tops of the
casters.
Page 5 OF 6
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
Step 7:
Attach the leg assemblies
2
and
7
to the
worksurface
1
using (16) wood screws
12
. Do not
over-tighten the screws. Use a low torque setting on the
power driver.
Step 8:
Align the holes in the u-channel
13
with the
pilot holes in the worksurface
1
. Attach it using (8) or
(10) wood screws
12
. Capture the switch wire in the
v-notch near the motor as shown below.
Step 9:
Align the holes in the control box
14
with the
pilot holes in the worksurface
1
. Attach it with (2)
wood screws
12
. Align the holes in the hand switch
15
with the pilot holes near the front of the worksurface.
Attach it with (2) sheet metal screws
17
. Capture the
switch wire in the clamp
18
and attach it with (1) wood
screw
12
in the location shown. No pilot hole is
provided. Attach the wire management J
17
to the
worksurface at the location shown below with (1) wood
screw
12
. No pilot hole is provided. Run the wires
from the switch and motor as shown below.
Step 10:
Plug the power cord from the control box
14
into a standard 110v receptacle. A power surge
protector is recommended. Press both arrows on the
hand switch
15
. The control box will reset and beep
once. Press the down arrow on the hand switch until the
leg assemblies
2
and
7
bottom out and the control box
beeps (3) times. The workstation is now ready for use.
Raise the leg assemblies high enough to fully tighten the
motor assembly screws. Tighten the screws and return
the leg assemblies to their lowest position.
Step 11:
With the help of an assistant, set the work-
station upright in its final position. Level the workstation
Critical procedure
that must be
performed at this
step and any time
the workstation
stops operating or
gets stuck in any
position. Damage
to the spindles
inside the leg
assemblies will
occur if this
procedure is not
followed.
Instruction # 53026
