PAGE 3 OF 3
STEP 7:
LEVEL THE CROSS SUPPORT
9
SO IT IS 4" FROM THE BOTTOM OF THE WORKSURFACE SUPPORT. SEE
DETAIL C. FULLY TIGHTEN ALL THE SOCKET SCREWS
11
. USE THE HEX HEAD DRIVER BIT OR THE ALLEN
WRENCH
13
PROVIDED.
SPECIAL EXCEPTION: FOR WORKSTATIONS ON WHICH THE LifeBalance™ STATION
IS BEING INSTALLED, THE CROSS SUPPORTS SHOULD BE ATTACHED RESTING ON THE FEET OF THE COLUMN
ASSEMBLIES TO ALLOW FOR CLEARANCE OF THE EQUIPMENT.
INSERT AN END CAP
12
INTO EACH END OF
THE CROSS SUPPORT.
STEP 8:
REPEAT
STEPS 4-6
WITH THE RIGHT HAND COLUMN ASSEMBLY
7
AND THE OTHER CROSS SUPPORT
9
.
STEP 9:
ATTACH THE WORKSURFACE SUPPORTS TO THE WORKSURFACE(S) USING (22) WOOD SCREWS
4
.
DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE SETTING ON THE DRILL.
STEP 10:
WITH THE HELP OF AN ASSISTANT, SET THE WORKSTATION UPRIGHT IN ITS FINAL LOCATION. LEVEL THE
WORKSTATION IF REQUIRED BY TURNING THE LEVELING GLIDES CLOCKWISE (FROM THE TOP) ON THE
LOW CORNERS OF THE UNIT. IF YOUR WORKSTATION HAS CASTERS, TURN THE BOLTS AT THE TOP OF THE
CASTERS CLOCKWISE TO LEVEL THE UNIT.
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
VERSION DATED: 3/30/12
K&A MANUFACTURING
LEVELING GLIDE
OR CASTER
4
WORKSURFACE
SUPPORT
STEPS 7-9
SUPPORT
BOTTOM OF
WORKSURFACE
LOCATING THE CROSS SUPPORT
(SEE EXCEPTION IN STEP 7)
DETAIL C
STEPS 7 & 8
9
4.00
