NewCrank SPLIT WORKSURFACE CRANK HEIGHT ADJUSTABLE WORKSTATION
HARDWARE PACK # 52226
PAGE 1 OF 2
SLIDING THE OTHER END OF
THE HEX ROD INTO THE HEX DRIVE ON THE COLUMN ASSEMBLY. YOU MAY
NEED TO TURN THE CRANK ON THE LEFT HAND COLUMN ASSEMBLY TO ALIGN
VERSION DATED: 3/6/12
1
STEP 2:
HARDWARE QUANTITIES MAY VARY
SURFACE.
COLUMN ASSEMBLY
THE HOLES IN THE WORKSURFACE SUPPORT WITH THE PILOT HOLES IN THE WORK-
THE INNER COLUMN MUST FACE THE CENTER OF THE WORKSTATION. ALIGN
PLACE THE LEFT HAND COLUMN ASSEMBLY
ON THE WORKSURFACE
AS SHOWN. THE HEX DRIVE AT THE TOP OF
LEVEL
2
INSERT THE END OF THE HEX ROD
TAPE MEASURE
4
ALLEN WRENCH PROVIDED
3
7/32" HEX HEAD DRIVER BIT OR
#2 SQUARE HEAD DRIVER BIT
INTO THE HEX DRIVE ON THE LEFT
#2 PHILLIPS HEAD DRIVER BIT OR
CORDLESS DRILL
(THE ASSEMBLY WITH THE
HAND COLUMN ASSEMBLY
CRANK) ON THE WORKSURFACE
TOOLS REQUIRED FOR ASSEMBLY:
ASSEMBLY INSTRUCTIONS:
2
1
STEP 1:
LAY THE FIXED WORKSURFACE
1
ON A PROTECTED SURFACE WITH THE
PILOT HOLES FACING UP.
AS FAR AS IT WILL GO. PLACE THE RIGHT HAND
STEP 3:
THE HEX ROD WITH THE HEX DRIVE. ALIGN THE HOLES IN THE WORKSURFACE
SUPPORT WITH THE PILOT HOLES IN THE WORKSURFACE.
INSTRUCTION # 52639
ITEM # PART #
DESCRIPTION
QTY.
1
VARIES NewHeights FIXED WORKSURFACE
1
2
VARIES NewCrank LEFT HAND COLUMN ASSEMBLY
1
3
VARIES NewCrank RIGHT HAND COLUMN ASSEMBLY
1
4
VARIES NewCrank HEX ROD
1
5
VARIES NewHeights CROSS SUPPORT
1
6
52477 3/8 INTERIOR TOOTH STAR WASHER
4
7
52470 3/8-16 x 3/8 BUTTON HEAD SOCKET SCREW
4
8
800411 NewHeights/HOVER END CAP
2
9
51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW
16
10
50219 NewHeights SWING ARM (300SW)
1
11
VARIES NewHeights MOVABLE WORKSURFACE
1
12
52498 7/32" ALLEN WRENCH
1
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
HEX
DRIVE
SUPPORT
WORKSURFACE
STEPS 1-3
1
2
4
3
READ ALL THE INSTRUCTIONS BEFORE BEGINNING
DO NOT OPERATE THE UNIT UNTIL IT IS FULLY ASSEMBLED
