SQUARE
PAGE 1 OF 3
TAPE MEASURE
TOOLS REQUIRED FOR ASSEMBLY:
VERSION DATED: 10/4/11
#2 SQUARE HEAD DRIVER BIT
#2 PHILLIPS HEAD DRIVER BIT OR
CORDLESS DRILL
BY PULLING THE
5
PAPER STRIPS OFF THE TRACK. SEE THE TOP VIEW BELOW. POSITION THE TRACK
SQUARE WITH THE FRONT OF THE WORKSURFACE AND BACK 3/8". PRESS THE
FROM THE BOTTOM UP AND INTO THE TRACK.
TRACK FIRMLY IN PLACE SO THE GLUE DOTS WILL HOLD THE TRACK ONTO
THE BOTTOM OF THE WORKSURFACE.
IMPORTANT NOTE: THE WORKSURFACE MATERIAL MUST BE COMPATIBLE WITH
THE SCREWS PROVIDED. THE WORKSURFACE MUST BE AT LEAST 1" THICK.
INTO THE FRONT OF THE TRACK. ATTACH IT USING (2) SELF
STEP 3:
ATTACH THE TRACK
1
INSTRUCTION # 52359
TO THE WORKSURFACE USING (6) WOOD
SCREWS
3
. DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE
SETTING ON THE DRILL.
STEP 4:
SLIDE THE ARTICULATING ARM
2
HARDWARE PACK # 52372 & 50531 (TRACK HARDWARE)
BACK INTO THE TRACK
TAPPPING MACHINE SCREWS
1
. INSERT
THE FRONT STOP
4
415/417NR NOTEBOOK TRAY AND ARTICULATING ARM INSTALLATION
INSTRUCTIONS:
STEP 1:
SLIDE THE ARTICULATING ARM
2
OUT OF THE TRACK
1
AND SET IT
ASIDE. DETERMINE THE LOCATION TO MOUNT THE TRACK AND ARTICULATING
ARM. LOCATE THE TRACK SO THAT THE ARM AND TRAY CAN ROTATE LEFT
AND RIGHT AS FAR AS YOU WANT IT TO ROTATE.
STEP 2:
EXPOSE THE GLUE DOTS ON THE TOP OF THE TRACK
1
ITEM # PART #
DESCRIPTION
QTY.
1
VARIES TRACK ASSEMBLY
1
2
VARIES ARTICULATING ARM ASSEMBLY
1
3
51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW
6
4
50232 FRONT STOP
1
5
50200 10-24 x 1/2 SELF TAPPING MACHINE SCREW
2
6
VARIES 415/417NR NOTEBOOK TRAY
1
7
52679 8-32 x 3/8 PHILLIPS TRUSS HEAD MACHINE SCREW
6
8
50267 8-32 SERRATED FLANGE LOCK NUT
6
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
5
BEFORE BEGINNING
4
1
2
3
READ ALL THE
INSTRUCTIONS
STEPS 1-4
GLUE DOTS
COVERING
PAPER STRIPS
1
