Phoenix HT User Manual
© 2007–2012 Rigaku Automation, Inc.
13
401718 Rev A
2.5. Using the Stop, Start, and Emergency Stop (EMO) Pushbuttons
Located on the Phoenix HT enclosure, the Start, Stop, and EMO pushbuttons are used as follows:
CAUTION:
If there is any concern at all about instrument crashing, use the EMO to
stop the machine.
2.6. Resetting the System after an Emergency Motor Off (EMO) Shutdown
To reset from an EMO state:
1. Rotate the red EMO button clockwise until it pops out.
2. Push the green push button to restore power. The Phoenix HT application restarts the Art
Robbins
Phoenix
application.
3. Push the green start button. The Phoenix HT application homes the motors. The Art Robbins
Phoenix
application connects.
4. Remove and discard the block that was in process.
5. Perform a wash.
6. In the
Jobs View,
select the job that was running when the EMO button was pushed.
7. Select
Jobs
from the menu bar, and select
Edit
Job
. Check the
Reset job status
check box to reset
the job.
8. To rerun the protocol, load and run the job.
EMO
Immediately shuts off power to the Phoenix HT instrument, stops movement, and stops
the Art Robbins Phoenix application.
Use the EMO button when there is a danger to the machine or to persons, for example,
if a tall plate is in a short plate slot.
See also “2.6. Resetting the System after an Emergency Motor Off (EMO) Shutdown” on
Stop
Pauses the Phoenix HT system at the end of the current protocol step.
Performs a “soft” stop, running the instrument until the end of the current protocol step
before stopping.
Start
Starts or resumes the sequence.
Restores power after an EMO, and also performs the same functions as the Start button
in the Rigaku Phoenix software.
Reset job status
check box
