BMD-34x-EVAL User Guide
Rev 2.0
6
5.2
Connect BMD-34x-EVAL to computer
The evaluation board is provided with an on-board Segger J-Link programmer/debugger.
1.
Connect the board to a computer using the USB cable provided.
2.
The status LED, D5, will flash and then turn solid once the USB device is enumerated.
3.
After a few seconds the computer will recognize the Evaluation Board as a J-Link device and
install the USB-Virtual COM Port device driver.
4.
Run the J-Link Commander:
a.
JLink
on Windows
b.
JLinkExe
on macOS and Linux
5.
Type “
connect
”
at the
J-Link>
prompt
6.
Enter the device type at the
Device>
prompt
a.
Type
nRF52840_XXAA
for the BMD-340
7.
Enter
S
to select the SWD interface and accept the default for the speed.
8.
J-Link will respond with several items. Here is a sample output:
Figure 3
–
J-Link Commander Output
