25
Multi-position saddle
To prevent falling and
resulting injury, the
hip corral strap should be used for all
non-weight-bearing clients, or any time
additional security is needed.
Attaching
Medium and large MPS, Figure 25a:
• To attach large saddle under upper frame
press button (B) and insert saddle upright
into the recess under the cross bar.
• To remove saddle press both button (A) and
safety button (B) simultaneously.
Small MPS, Figure 25b:
• To attach the small saddle under the upper
frame push the upright square tube into the
recess under the cross bar.
• To remove the small saddle, push the two
spring buttons indicated and remove saddle
from the recess under the cross bar.
Adjustments
Figure 25c:
• To adjust height
press trigger (C).
• To adjust seat angle
press button (D).
• To adjust seat forward or backward
press trigger (E).
• To adjust hip corral in or out,
or to
attach or remove it, press trigger (F).
• To remove seat
fi rst remove hip corral,
then slide seat using trigger (E) as far back as
possible. Finally, press 2 buttons on each side
(G) to complete removal.
• To adjust hip corral height
press
trigger (H).
• To attach corral strap
clip hook onto
rear of seat. The corral strap as well as the
pads on the hip corral can be removed, if
desired. To remove pads, undo hook and loop
patch between pads and slide pads off bar.
To detach corral strap, remove pads, then
press small white buttons near end of bar
and pull rings from slots.
Figure 25a
A
A
B
B
Figure 25b
WARNING
Tip:
Every white lever or button indicates a
point of adjustment.
A
A
B
B
Figure 25c
C
C
E
E
D
D
G
G
F
F
H
H
