Rifton MultiDesks E280, Product Manual, Page: 6 / 8

6
set of snap-on Edges
Recommended Use
The set of Snap-on Edges can be used to help keep things on the desk and to
clamp a sheet of paper.
Assembly
Snap-on Edges are assembled onto your MultiDesk. You should have three
Snap-on Edges: one long edge and two shorter edges.
Operation
To attach the Snap-on Edges to your MultiDesk, take the longest piece and
position it in the center of the top edge. Then push the two clips so that they are
snug against the edge of the desk. You should hear them snap in. Double check
that both clips are in. If you are having trouble snapping the edge on, check that it
is centered, and that it is the correct length (Snap-on Edges should be two inches
shorter than the edge of the desk). Do the same for the two shorter pieces, which
go on the sides. To remove the Snap-on Edges, release clip tension under top.
WARNINGS
This accessory is intended for use on the following Rifton Equipment
products only:
E270 Small MultiDesk •
E280 Large MultiDesk •