11
Hand loop set with
mounting bracket
Recommended use
The mounting bracket and hand loops are for use with Dynamic Standers only.
The arm prompt set gives additional support for a client with poor head and/or
shoulder control. It stimulates the client to raise his/her head. The mounting
bracket is needed to attach the hand loops on the Dynamic Stander.
Installation of
mounting bracket
See instructions for installation of mounting
bracket on page 9 (see Figure 9a).
Hand loop set
Loosen the clamp knob (C) and pull it
down to free the curved metal piece.
Slip the clamp over the oval tube of
the mounting bracket with the white
adjustment button (F) to the outside of the
mounting bracket. Close the curved metal
piece, pull the knob up, and tighten it
securely (see Figures 9b and 9c).
Adjustments
Loosen knob (C) to completely remove
hand loop from mounting bracket.
Loosen knob (D) to tilt the hand loop to
desired position. Tighten knob securely.
Press button (F) to adjust the height of
hand loop. Slide post up or down to desired
position. Release button to engage into
desired position (see Figure 11a).
Figure 11b
Figure 11a
C
C
D
D
F
F