7
Seatbelt
To prevent falls,
strangulation, head
entrapment or other injuries, always use
seatbelt when the tray, chest strap or
headrest are in use.
Every HTS is provided with a seatbelt.
To attach the seatbelt insert the seatbelt
attachment clip (see fi gure 7b) into the
socket at the back end of the side piece.
Check to ensure that the seatbelt latches
into place.
For users that tend to slide forward on
the seat, you may benefi t from threading
the seat belt to the inside of the backrest
supports (see fi gure 7c).
On the small HTS there is an additional
option for seat belt threading to ensure a
more secure positioning for small active
users. Thread the seat belt through the
hooks provided at the bottom back edge of
the seat (see fi gure 7d).
Backrest installation
or removal
To install the backrest: Tip the backrest
toward the front (see fi gure 7a). Insert the
bottom end of the backrest between the
latch plates while raising the backrest angle
triggers. Firmly press down on the backrest
while rotating it back towards the fi rst
latched position.
To remove the backrest, adjust the back
angle all the way forward. Then lift the
backrest up.
Figure 7b
Figure 7a
Angle triggers
Latch
plates
Clip
Figure 7c
Figure 7d
WARNING
