Riello RRS 68/E O2 BLU, Installation, Use And Maintenance Instructions

Page: 11 / 56

9 20169327 GB
Technical description of the burner
4.6 Maximum dimensions
The dimensions of the burner are shown in Fig. 1.
Bear in mind that inspection of the combustion head requires the
burner to be opened and the rear part drawn back on the guides. The dimensions of the open burner are indicated by position I.
Tab. E
(1) Blast tube: short-long
4.7 Firing rates
The maximum output is chosen within area A (and B for
RS 120/E O
2
BLU) of the diagram (Fig. 2).
The minimum output must not be lower than the minimum limit
of the diagram.
mm B C D E F G H
I-I
(1)
L M N P
T-T
(1)
V-V
(1)
RS 68/E O
2
BLU
217 137 189 425 2” 305 640 200-335 575 270 221 1010 255-390 1350-1485
RS 120/E O
2
BLU
217 137 189 425 2” 330 640 200-335 600 270 221 1010 255-390 1350-1485
Fig. 1
L
M G
E
N
F
V - V ( 1 )
P
C
B
T - T ( 1 )
H
I ( 1 ) *
I *
D
20150720
WARNING
to use area B (RS 120/E O
2
BLU) as well, the pre-
calibration of the combustion head is necessary,
as explained in the paragraph
"Pre-calibrating
the combustion head" on page 23.
CAUTION
The firing rate (Fig. 2) of the model RS 120/E O
2
BLU refers to the operation with fuel G20 - G25.
WARNING
The firing rate (Fig. 2) was obtained considering a
room temperature of 20°C and an atmospheric
pressure of 1013 mbar (approx. 0 m above sea
level), with the combustion head adjusted as
shown at page 23.
Thermal power
Fig. 2
20174990
Thermal power
Co
mbustion chamber
pr
essure -
mb
ar
Co
mbustion chamber
pr
essure -
mb
ar