USE
13
is restored the unit will resume operation with the previously
active settings.
If the Timer function was active, the time of interruption is not
counted.
If the compressor was in operation, restart is delayed by 3 min-
utes.
If the compressor was off, restart is immediate.
2.4
Temporary shutdown
In order to shut down the unit for periods of brief absences:
—
deactivate the unit using only the on-board control panel
or remote control
2.5
Stop for an extended period of time
If the device has not been used for an extended period of time,
carry out the following operations:
—
start the device in ventilation mode
—
select the maximum speed
—
let the device run for 6 hours
—
deactivate the device with the control panel or the remote
control
ON
OFF
—
set the system main switch to “OFF”
2.6
Maintenance
Routine maintenance is fundamental for keeping the equip-
ment efficient, safe and reliable. It can be performed periodi-
cally by
R
Technical Support Service, whose staff is technical-
ly qualified and can use genuine spare parts, if necessary.
Cleaning
The only cleaning operations required of the user concern the
remote control, the device cover, the front panel and the mesh
filter.
9
All described operations MUST be carried out under the fol-
lowing conditions:
—
cold device
—
device NOT supplied with electric power
—
suitable personal protection equipment
ON
OFF
0
It is forbidden to open the access doors and carry out any
cleaning operation before disconnecting the device from the
power supply positioning the system main switch to “OFF”.
Cleaning the remote control
—
clean with a soft and dry cloth
Cleaning the housing and front panel
—
wet a sponge or soft cloth with water and soap to wash
—
once cleaning is over dry surfaces with care
9
Do not use water at a temperature that is higher than 40°C,
powder or abrasive detergents, solvents and brushes.
mesh filter cleaning
1
Intake grid
2
Mesh filters
1
2
To remove the intake grille:
—
push it downwards
—
slide it forward
—
remove it by lifting
After having removed the intake grille:
—
extract the mesh filter
—
remove dust with an vacuum cleaner
9
If there is a considerable amount of dust, wash it with luke-
warm water (max 40°C) and a neutral detergent, carefully
rinse it off and let it dry in the shadow.
9
Exposing the filters to the sun or washing them with water
at a temperature that is higher than 40°C can cause the fil-
ters to shrink.
0
It is forbidden to use the device without mesh filter.
