- 0MNACCSA4ENQB -
INSTALLATION
1.
Remove the cover of the UPS expansion
slot by removing the two retaining screws.
2.
Insert
NetMan 204
in the slot.
3.
Secure
Netman 204
in the slot using the
two screws removed previously.
4.
Connect the device to the network by
means of connector RJ-45
Configuration via USB
To configure
NetMan 204
via USB it is necessary to:
·
connect, with the USB cable provided, the micro-USB port with the USB port of a PC with
Windows operating system;
·
if not previously installed, install the USB driver present in the bundled CD (after driver
installation, a virtual COM named “NetMan 204 Serial” will be present in device
manager);
·
execute a terminal emulation program with the following settings: 115200 baud, no parity,
8 databits, 1 stop bit, no flow control;
·
press the “Enter” key of the PC;
·
at the login prompt, enter “admin”;
·
at the password prompt, enter the current password (default password: "admin").
During password's typing, no character is shown.
Once login has been effected, the screen of the start menu is displayed. From this screen it is possible
to access the various menus to change
NetMan 204
settings.
Configuration via SSH
To configure
NetMan 204
via SSH it is necessary to:
·
execute a SSH client on a PC connected in a network to
NetMan 204
set with the IP address
of the device to be configured;
·
at the login prompt, enter “admin”;
·
at the password prompt, enter the current password (default password: "admin").
During password's typing, no character is shown.
Once login has been effected, the screen of the start menu is displayed. From this screen it is possible
to access the various menus to change
NetMan 204
settings.
CONFIGURATION
NetMan 204
can be configured via USB, via SSH or via HTTPS.
NetMan204
comes provided as factory default with DHCP enabled and with the following
services active: SSH, HTTP, SNMP, UDP and FTP.
In order to change the configuration of
NetMan 204
, you have to log in as admin (default
password “admin”).
NetMan 204
needs approx. 2 minutes to become operational from when it is powered
up or after a reboot; before this time the device may not respond to commands that are
sent to it.
Configuration via HTTPS
In order to change the configuration via https, you have to insert in your web browser the hostname or
IP address of the
NetMan204
and then log in as admin (default password: "admin").
The HTTP service uses TLS (transport layer security) in order to provide cryptographic
security. However, the certificate used is self-signed and therefore the web browser may
prompt a security alert; in this case you can ignore the alert and proceed with the
configuration of
NetMan204.
Once login has been effected, you can browse through the menus to configure the
NetMan 204
.
In order to make a new configuration effective, it is necessary to confirm it (OK button for
each configuration page changed) and then reboot the NetMan 204 (as required with a pop-
up by your web browser).
JP2
JP3
JP4
JP1
DEFAULT JUMPER SETTING
