Riedel Bolero 2.0, User Manual

Page: 89 / 130

89
Bolero 2.0 User Manual
4.4.3.1 Action Button (IO Devices)
Clicking the action button offers functions to
manage IO devices.
The dialog can be closed by pressing the ESC key
without saving any changes.
Figure 128: Action Button (IO Devices)
Create IO Device Configuration
Function in the region
IO Device Configurations
to create a new IO Device configuration.
General ID Defines the unique ID of the configuration.
Type Shows the device type of configuration.
Name Defines the configuration name.
Multicast IP Defines the multicast IP of the audio stream to be transmitted.
Triggers Input 1 ... 3 Slider to enable up to three input triggers. Disabled interfaces
are not shown in
drop-down menus.
Output 1 ... 3 Slider to enable up tp three output triggers.
Audio
Channels Pair
1 ... 6 Off Disables the audio channel of the respective port.
In and Out Enables the input and output audio channel of the respective port.
4-Wire Enables the 4-Wire of the respective port.
Input Enables only the input audio channel of the respective port.
Output Enables only the output audio channel of the respective port.
Add IO Devices
Function in the region Unassigned / Unconnected IO Devices that allows adding IO devices.
A single IO device must be selected previously.
Select IO Device Config Selection of an existing configuration or creation of a new configuration. Creating a new
configuration is identical to the feature
Create IO Device Configuration
.
Assign Hardware
Function in the region
IO Device Configurations
that assigns IO devices to a device configuration.
Select Hardware
to assign Selection of an IO device that should be assigned to the previously selected
configuration.
Unassign Hardware
Executing this command will remove the assigned IO device from the selected configuration without confirmation.
Remove Config
Allows removing one or more selected configurations. A dialog is opened to confirm the action.
This will remove all associated audio channels, triggers and key bindings.
Locate IO Device
Allows identifying the selected IO device visually. The LEDs on the front side of the respective IO device will start
flashing for about 15 seconds.
Clear Assigned Net
Unconnected and existing IO devices in other network spaces can be made available by this feature.
The respective IO device must be selected previously.
This action requires the "Admin PIN" of the Network Space.