6
SPECIFIC SAFETY INSTRUCTIONS
FOR RIDGID WET TILE/STONE SAW
Safety Instructions for Wet Tile/Stone Saw
WARNING:
Be sure to read and understand all instructions in this
manual before using this Professional Wet Tile/Stone
Saw with Laser Guide, LED Work light and Stand. Failure
to follow all instructions may result in electric shock, fire
and/or serious personal injury
WARNING:
To reduce the risk of mistakes that could cause serious,
permanent injury, do not plug the tile saw into an electri-
cal receptacle until the following steps have been satis-
factorily completed:
• COMPLETELY ASSEMBLE THE SAW
(See “Assembly”
section, page 13)
• LEARN THE USE AND FUNCTION OF THE ON-OFF
SWITCH,
blade guard, laser-adjustment knob, overload
protector, spindle lock, depth-stop-adjustment knob,
depth-adjustment knob, bevel-cut-adjustment knob, uni-
versal guide, etc. (See “Getting to Know Your Tile Saw” on
page 4.)
• REVIEW AND UNDERSTAND ALL SAFETY INSTRUC-
TIONS AND OPERATING PROCEDURES
in this manual.
• REVIEW THE MAINTENANCE METHODS
for this saw
(See “Maintaining Your Saw” section, page 35).
•
NEVER
put your fingers or hands in the path of the saw
blade or other cutting tool.
•
NEVER REACH BEHIND
the cutting tool with either hand
for any reason. Do not reach behind the blade to hold
down the work piece, support the work piece, remove
scraps, or for any other reason.
•
NEVER
use a hand position where a sudden slip could
cause the fingers or the hand to move into a saw blade.
• FIND AND READ ALL THE WARNING LABELS
found
on the tool (shown below).
1. To reduce the risk of electric shock, connect
only to a properly grounded, grounding type
receptacle.
2. To reduce the risk of electric shock, install
only on a circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI).
3. Risk of electric shock - This pump has not
been investigated for use in swimming pool or
marine areas.
PP-399
Submersible Pump
120V 0.23A 60Hz
E204083
63VF
WARNING
CAUTION
IMPEDANCE PROTECTED
Acceptable For Indoor And Outdoor Use
This pump has been evaluated for use with
water only.
FOR YOUR OWN SAFETY, READ INSTRUCTION
MANUAL BEFORE OPERATING SAW
A) WEAR EYE PROTECTION
B) USE SPLASH HOOD FOR EVERY
OPERATION FOR WHICH IT CAN BE USED
C) DISCONNECT SAW BEFORE SERVICING,
WHEN CHANGING CUTTING BLADES, AND
WHEN CLEANING
D) USE TOOL ONLY WITH SMOOTH-EDGE
CUTTING BLADE FREE OF OPENINGS AND
GROOVES
E) REPLACE DAMAGED CUTTING BLADE
BEFORE OPERATING
F) DO NOT EXPOSE TO RAIN OR USE IN
DAMP LOCATIONS
LEE ESTA INSTUCCION MANUAL ANTES DE USA LA
SIERRA PARA TU BIEN
A) PONE EL PROTECTOR PARA LOS OJOS
B) USA UNA CAPUCHA PARA PROTEGERSE DE
LAS MANCHAS CUANDO USA LA SIERRA
C) DISCONECTA LA SIERRA CUANDO NO ESTA
USADA, O VA A CAMBIAR LA RUEDA DE CORTAR, O
VA A LIMPIARLA
D) CUANDO SE USA, SOLO USA LA PARTE LISA
DE LA RUEDA DE COETAR, Y DEJA LIBRE LA OTEA
PARTE Y LA PANURA
E) ANTES DE USAR LA SIERRA, TIENE QUE
CAMBIAR LA ROTA RUEDA DE CORTAR
F) NO LA DEJES EXPUESTA A LA LLUVIA NI LA
USES EN CONDCIONES MOJADAS
POUR ASSURER VOTRE SECURITE, LISEZ LE
MODE D'EMPLOI AVANT D'UTILISER LE COUPEUR
A) PORTEZ LES LUNETTES DE PROTECTION
B) PORTEZ LA CASQUE DE PROTECTION
PENDANT CHAQUE OPERATION
C) DECONNECTEZ LE MEULE AVANT
L'UTILISATION QUAND ON CHANGE LE MEULE DE
COUPAGE OU LE NETTOIE
D) UTILISEZ SEULEMENT L'OUTIL WITH LE
MEULE A BORD LISSE SANS RAINURE
E) REMPLACEZ LE MEULE AVEC DEGRATS
AVANT L'OPERATION
F) N'EXPOSEZ PAS DANS LA PLUIE OU UTILISE
DANS L'ENVIRONNMENT HUMIDE
MISE EN GARDE
ìST OP/GOî knob must be in the ìST OPî position before operating, moving or transporting
the saw.
For your safety, use the table lock to secure the working table before moving or transporting
the saw.
Líinterrupteur ´ marche/arrÍt ª doit Ítre en position ´ arrÍt ª avant díutiliser
, de dÈplacer ou de
transporter la scie.
Pour votre sÈcuritÈ, enclenchez le verrouillage du plateau de travail avant de dÈplacer ou
transporter la scie.
La perilla de STOP/GO debe estar en la posiciÛn de ST OP (PARADA) antes de funcionar , de
mover o de transportar la sierra.
Para su seguridad, utilice la cerradura de la mesa para asegurar la mesa de trabajo antes de
mover o de transportar la sierra.
Summary of Contents for WTS2000L
Page 39: ...39 Exploded Drawings and parts lists WTS2000L Tile Saw...
Page 41: ...41 Notes...
Page 42: ...42 Notes...
Page 43: ...43 Notes...
