6
1. Line up front of Power Head Assembly
with Vacuum Inlet Port located on the
front of the Drum, as shown.
2. Place Power Head Assembly on top of
Drum.
3. Be sure Power Head Assembly
completely covers the top of the
Drum so leakage does not occur.
4. Push down on the top of the Power
Head Assembly to engage the Flexible
Locking Tabs of the Drum into the
Power Head Latch Lock Holes.
5. Make sure that the Locking Tabs are
snapped in place to prevent the Power
Head Assembly from coming off.
(See inset).
Your new Wet/Dry Vac is ready for use.
Wet/Dry Vac Assembly
Drum
Channel
Power Head
Assembly
Drum
Flexible
Locking Tab
Power Head
Assembly
Pull Out
Flexible
Locking
Tab
Push
Down
Insert Hose
Insert the push button end of the
Tug-A-Long Positive Locking Hose into
the Vacuum Inlet Port of the Vac.
The Hose should snap into place.
To remove the Hose from the Vac,
press the release button on the Hose
Assembly and pull the Hose out of the
Vacuum Inlet Port, as shown.
Power
Head
Assembly
Vacuum
Port
Release
Button
Vacuum
Inlet Port
Tug-A-Long
Positive Locking
Hose
Latch Lock
Hole
Vacuum
Inlet Port
SP6975-3 16 GALLON.indb 6
SP6975-3 16 GALLON.indb 6
4/21/20 2:45 PM
4/21/20 2:45 PM
