6
1. Line up vacuum port above drum label.
2. Place lid on top of drum with the
handles snug against the drum
channel.
3. Be sure lid completely covers the top of
the drum so leakage does not occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid from
coming off (see insert).
Wet/Dry Vac Assembly
Place the utility nozzle securely on the
flexible plastic end of the hose and the vac
is ready for use.
Insert Hose
Insert the push button end of the “Tug-a-
Long” hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Release Button
Flexible Locking
Tab Pulled Out
Flexible
Locking Tab
Drum
Vacuum Port
Powerhead
Push Down
and Pull Out
Flexible
Locking Tab
(located
under latch)
Drum
Channel
Replacement Filter Assembly (continued)
1. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down over
the hole.
2. Line up filter cage tabs with slots in the
center ring of the lid.
3. Push on the filter cage until the tabs
snap into slots for a secure fit.
WARNING: To avoid personal injury
or damage to vac be sure to keep
hands, fingers, or any other foreign
objects out of the center opening
when assembling the float .
Filter
Cage
Tabs (3)
Slots
(3)
Power
Assembly
THIS SIDE
TOWARD LID
Filter
Cage
Tabs (3)
Float
Solid End
Slots (3)
SP6480-5ES 8/24/06 10:28 AM Page 6
Downloaded from
www.Manualslib.com
manuals search engine
