RIDGID R84087, Operator'S Manual, Page: 8 / 36

8 - English
OPERATION
AM/FM TUNING
See Figure 4, page 13.
The left and right arrow buttons and the
MODE
button are
used to tune to the desired radio frequency. The selected
frequency is displayed on the LCD.

Press the MODE button until AM or FM is highlighted.

Press and release the left arrow button to tune to a lower
frequency. Press and release the right arrow button to
tune to a higher frequency.
Briefly push either button (not press and hold) to tune one
frequency step at a time.

To SEEK , press and hold desired arrow button for 3 sec-
onds to tune to the next frequency with clear reception.
 To
SCAN
, press and hold both arrow buttons for 3 sec-
onds to scan through all the frequencies with clear
reception.
NOTE: When scanning, the radio will stop on frequencies
with clear reception for three seconds before continuing
to the next higher frequency.
Press
PRESETS
to stop scanning and select a frequency.
If no frequency is selected, the radio will return to the
frequency that was displayed when the scan was started.
STORING A PRESET IN MEMORY
See Figure 4, page 13.
The memory feature saves up to 20 frequencies as presets
in the radio’s memory. You can save 10 frequencies in FM
mode and 10 in AM mode.
To store a frequency in memory:

Tune to the frequency you want to save.

Press and hold the PRESET button for 3 seconds. A
memory location number will blink on and off.

Press either arrow button to scroll through the preset
positions.

Press the PRESET button to store the frequency in the
selected memory location.
To recall a preset frequency:

Press the PRESET button and quickly release to cycle
through stored frequencies.
TONE SELECTION
See Figure 4, page 13.

Press the
SOUND
button to enter bass adjust mode.

Adjust the bass setting using the volume knob.

Press the SOUND button to save the new bass setting
and enter treble adjust mode.

Adjust the treble setting using the volume knob.

Press the SOUND button to save the new treble setting
and return to original operating mode.
STREAMING AUDIO USING A BLUETOOTH
®
ENABLED DEVICE (NOT INCLUDED)
See Figures 4 - 5, pages 13 - 14.
 Press the button to enter BLUETOOTH ® mode. You
can also enter BLUETOOTH ® mode by pressing the
MODE
button to cycle through available modes until
is highlighted.
NOTE : The radio will automatically attempt to connect
to the last device it was paired to. If no device has been
previously paired, will automatically begin blinking.

Set your device to search/scan for available BLUETOOTH
®
signals, then select “STRM–RIDGID Jobsite Radio” from
the list. No password or PIN is required for connection.
 When the device has successfully paired with the radio,
you will hear an audible tone and will stop blinking.
NOTE: If the radio does not pair with your device, turn
the power to the radio off, wait 5 seconds, then turn the
power back on and start the pairing process again.

When streaming audio from a BLUETOOTH
®
enabled
device, press the arrow buttons on the radio to go to the
previous or next track. Press the
PRESET
button to cycle
between pausing and playing the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
®
device and/or streaming application you
are using.

To reach maximum volume when controlling the sound
using the radio’s volume knob, make sure the volume on
your device is also at the maximum setting.

To disconnect the current device to allow connection to
another BLUETOOTH
®
enabled device, press and hold
the button for 3 seconds. When begins to blink, the
radio is ready to pair.