MAKI NG ADJUSTMENTS
Figure 34
Figure 35
Figure 36
If the distances are different:
3.
L
oosen the front trunnion bolts using a 5mm Hex Wrench,
found below the table top. See Figure 34.
4.
Loosen the rear trunnion bolts using a 5mm Hex Wrench,
found below the table top. See Figure 35.
5.
I f t he rear of t he blade was t oo close t o combinat ion
square, place a block of wood on t he right side of t he
blade. Lightly tap with a small hammer or rubber mallet to
achieve the correct parallelism adjustment . See Figure 36.
6.
Re-tighten the trunnion bolts using the 5mm Hex Wrench.
Recheck alignment after bolts are re-tightened.
23
