41
−
English
TROUBLESHOOTING
Problem
Cause
Solution
Saw does not make accurate 90˚ or
45˚ cuts.
Positive stops inside cabinet need
adjusting (Bevel Cuts).
Miter gauge is misaligned (Miter Cuts).
Adjust positive stops.
Adjust the miter gauge.
Height/bevel adjusting handwheel is
hard to turn.
Gears or screw post inside cabinet
are clogged with sawdust.
Clean the gears or screw post.
Saw does not start.
Motor cord or wall cord is not plugged
in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have replaced by qualified service center.
Blade makes poor cuts.
Blade is dull or dirty.
Blade is wrong type for cut being
made.
Blade is mounted backwards.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Blade does not lower when turning
height/bevel adjusting handwheel.
Blade cover is dirty.
See cleaning instructions in the
Mainte-
nance
section.
Motor labors in rip cut.
Blade not proper for rip cut.
Change blade; rip blade typically has
fewer teeth.
Summary of Contents for R45171
Page 43: ...43 NOTES NOTAS...
