![RIDGID R4512 Operator'S Manual Download Page 53](http://html1.mh-extra.com/html/ridgid/r4512/r4512_operators-manual_1458789053.webp)
53 - English
TROUBLESHOOTING
Problem
Cause
Solution
Saw does not make accurate 90˚ or
45˚ cuts.
Positive stops inside cabinet need
adjusting (Bevel Cuts).
Miter gauge is misaligned (Miter Cuts).
Adjust positive stops.
Adjust the miter gauge.
Height and/or bevel adjusting hand-
wheel is hard to turn.
Gears or screw post inside cabinet are
clogged with saw dust.
Clean the gears or screw post.
Saw does not start.
Motor cord or wall cord is not plugged in.
Circuit fuse is blown.
Circuit breaker is tripped.
Cord or switch is damaged.
Plug in motor cord or wall cord.
Replace circuit fuse.
Reset circuit breaker.
Have the cord or switch replaced by
qualified service center.
Blade makes poor cuts.
Blade is dull or dirty.
Blade is wrong type for cut being made.
Blade is mounted backwards.
Clean, sharpen, or replace blade.
Replace with correct type.
Remount blade.
Blade does not lower when turning
height adjusting handwheel.
Locking lever is not at full left position.
Blade cover is dirty.
Move locking lever to left.
See cleaning instructions in the
Maintenance
section.
Motor labors in rip cut.
Blade not proper for rip cut.
Change blade; rip blade typically has
fewer teeth.
Summary of Contents for R4512
Page 159: ...15 NOTES NOTAS ...