RIDGID R4093, Operator'S Manual

Page: 33 / 112

33 — English
ADJUSTMENTS
TO ADJUST THE SLIDING TABLE
See Figure 57.
If the table doesn’t slide smoothly, seems too loose on the
frame, moves side to side, or is visibly off track, adjustments
may be required.

Remove frame and sliding table from the saw.

Turn the frame and sliding table upside down and locate
the adjustable rollers.

Loosen the adjutsment and pivot screws.
NOTE: The adjustment screws are seated inside slots in
the bracket.

Move the brackets in or out until the rollers are touching
the frame rails. Tighten adjustment screws and pivot
screws.

Move the sliding table along the frame to ensure that the
rollers are sliding properly.

If further adjustments are required, repeat the steps above
until sliding table moves properly.
Fig. 57
ADJUSTABLE
ROLLERS
ADJUSTMENT
SCREW
ADJUSTMENT
SCREW
PIVOT
SCREW
BRACKET
SLOT
FRAME
RAIL