14
OPERATION
CAUTION:
Excessive side pressure to the blade could result
in broken blades or damage to the material being
cut.
SCROLL CUTTING
See Figure 12.
Scroll cuts can be made with the saw by guiding the direc-
tion of the cut with applied pressure on the handle as shown
in figure 12.
Fig. 12
BEVEL CUTTING
See Figures 13 - 14.
Bevel cutting angles may be adjusted from 0° to 45° right
or left. Angles for cuts from 0° to 45° in 15° increments are
marked on a scale on both the left and right side of the base.
Lines are also drawn from the middle section to the back of
the base for accurate alignment.
An arrow under the motor assembly provides an indicator at
each of the 15° increments. A protractor is recommended
for making accurate cuts.
Unlock the base by moving the base locking lever forward
and sliding the base forward from the locking pin.
Select the desired angle on the base.
Once the desired angle is reached, slide the base back-
ward to the locking pin and tighten the base locking
lever by moving the base locking lever under the motor
assembly.
Fig. 13
Fig. 14
LOCKING
LEVER
TO
UNLOCK
TO
LOCK
TO
UNLOCK
BASE
30
0
45
15
15
30
45
LOCKING
PIN
NOTCHES
IN BASE
DEGREE
MARKS
TO
LOCK
