25
OPERATION
0
WRONG
WARNING:
To avoid a kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 32.
When cutting wide workpieces, such as 2 in. x 6 in., boards
should be clamped with a C-clamp as shown in figure 32.
Bevel
Angle
Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save right end of cut
33.85
°
33.85
°
33.85
°
33.85
°
Fig. 32
CUTTING WARPED MATERIAL
See Figures 30 and 31.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 30.
If the warped material is positioned the wrong way as shown
in figure 31, it will pinch the blade near the completion of the
cut.
WIDE
BOARD
Fig. 31
Fig. 30
RIGHT
