KWIK-SPIN+
™
Hand
Spinner Instructions
WARNING
Wear appropriate protective equipment
including safety glasses and leather
gloves. Drains may contain hazardous
chemicals or bacteria.
If you have any question concerning this
RIDGID
®
product:
• Contact your local RIDGID distributor.
• Visit RIDGID.com to find your local RIDGID
contact point.
• Contact RIDGID Technical Services Depart-
ment at [email protected], or in
the U.S. and Canada call (800) 519-3456.
Figure 1 – KWIK-SPIN+
™
Hand Spinner
Specifications
The KWIK-SPIN+
™
Hand Spinner cleans
drain lines up to 1½" in diameter. It is not rec-
ommended for toilets. The cable is positively
retained in the drum to prevent cable pullout.
Before Use
Inspect KWIK-SPIN+
™
Hand Spinner. Do not
use if damaged. Inspect the drain. Determine
if chemicals are present. Some chemicals
have specific health and handling consider-
ations that should be provided by the manu-
facturer. Confirm KWIK-SPIN+
™
hand spinner
is appropriate for the job.
Drain Access
• Thread through crosshairs
(Figure 2)
.
• Unscrew cleanout plug or remove trap
(Figure 3)
.
KWIK-SPIN+
™
Hand Spinner
999-999-473-10,
REV. A.
Printed 7/17
EC43071
© 2017, RIDGID, Inc.
The Emerson logo and RIDGID logo are registered trademarks of Emerson Electric Co. or RIDGID, Inc. in the U.S. and other countries.
All other trademarks belong to their respective holders.
• Pop-up Drain: Remove lift rod and drain
plug
(Figure 4)
.
• Bathtub overflow: Remove overflow plate
and internal mechanism
(Figure 5)
.
Operating Instructions
1. Insert cable into drain. Position unit as close
to drain as possible. Squeeze trigger to
engage the AUTOFEED
®
mechanism.
2. Turning drum clock-
wise advances cable.
Counter-clockwise
re-tracts cable.
Cable can also be
rapidly advanced/
retracted by hand.
Advance cable until
you encounter the blockage
(Figure 6)
.
3. Work cable through blockage. DO NOT force
cable. Work cable back and forth 2-3 times.
4. Retract cable
(Figure 7)
. After flow is estab-
lished, if possible run water to clear debris
and clean cable
(Figure 8)
.
5. Rinse cable and drum. Air dry before storage
to prevent rust.
AUTOFEED
®
Mechanism
Cable
Trigger
Handle
Crank
Drum
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
KWIK-SPIN is a registered trademark of RIDGID, Inc. in the U.S.
