SeeSnake Diagnostic Equipment
Kollmann
6
Tilt Stand Small kick stand on bottom of Monitors.
This helps raise the angle of the screen when the
a metal ring embedded around the perimeter of the
LED ring that helps extend the life of this component.
Locking Sleeve This device is found at the rear of
the camera, within the spring. It holds the connector in
place and serves as an anchor for the safety cables.
This device is unscrewed from the back of the camera
to detach the connector from it.
Monitor The “television” in the system. RIDGID/Koll-
mann monitors include the power pack within them
and have a dimmer knob to adjust the LED brightness
for varying pipe conditions. They also include a sun-
shade, tilt stand, handle, and AC cord storage hooks.
Power Pack This component is supplied with sys-
tems where a monitor is not ordered. The power pack
converts 120 volt AC (or 230V) power from a wall out-
let to ~12 volts DC power to run the camera head
(video and lights), as well as any options. Its features
include a power switch, connector (female to intercon-
nect cable), a dimmer, and a video out jack providing
a signal to your monitor.
Reel The gray plastic portion of the system that holds
the push cable and camera.
Safety Cables Stainless steel cables (two) within the
spring assembly that connect between the push cable
termination and the locking sleeve holding the con-
nector at the back of the camera head. These prevent
the spring from over-extending when pulling the cam-
era out of a pipe. Together, they provide over 800
pounds of breaking strength.
Sapphire Window The small, round port that the
camera “looks” through. This component is virtually
scratch-proof providing excellent video throughout the
life of the system.
Spanner Wrench 0ne-piece wrench used to engage
the end of the spring when removing the camera
head. To remove the camera from the spring, you
must use a spanner wrench.
Spring Assembly Flexible stainless steel spring and
associated components that hold the camera to the
push cable, provides a flexible transition from camera
to push cable, and protects the terminations within the
spring.
Sunshade This metal device is included on monitors
to protect the screen when system is not in use
(closed) and to optimize the picture in bright sunlight
(opened).
Brake
Interconnect Cable
Axle
Reel
Dolly
