RIDGE RYDER RR50A, Manual

Page: 8 / 30

PAGE 8
You can charge the battery or transceiver separately .
1.Plug the AC adaptor into the AC outlet, and then plug the cable of the AC adaptor into the DC jack
located on the back of the charger. Charging indicator---Red.
2.Plug the battery or transceiver into the charger. Make sure that the battery is well connected with
charging connectors. Charging indicator---Red. Once fully charged. Charging indicator---Green.
It takes approximately 4 hours to fully charge the battery. But, the actual charging time depends on
the dump battery. After fully charged, please remember to remove the battery or transceiver out of
charger. Over charging will shorten the battery life and reduce its performance.
Connect the transceiver directly with adaptor or car charger to charge.
Note :
Please power off the transceiver before charging the transceiver in this way. Also, it takes
longer time (totally 12hours) to fully charge the transceiver in this way.
How to Store the Battery
1.If the battery needs to be stored, keep it in status of 50% discharged.
2.It should be kept in low temperature and dry environment.
3.Keep it away from hot places and direct sunlight.
WARNING:
▲ Do not short circuit battery terminals.
▲ Never attempt to remove the casing from the battery pack.
▲ Never assemble the battery in dangerous surroundings, sparks may cause an explosion.
▲ Do not put the battery in hot environment or throw it into a fire, it may cause an explosion.
CHARGING & BATTERY MAINTENANCE