G
H
INPUT
Charging
• The POWER SWITCH must be turned in
OFF
position when charging.
• Before the first use, you should charge the battery
for 4-6 hours. Do not recharge the battery for more
than 10 hours to avoid overheating the charger.
• When the vehicle begins to run slowly, recharge the
battery.
1. Open the charger cover. Plug the charger
port into the input socket. (The input socket is
above the right foot board.)
2. Plug the charger plug into a wall outlet. The
battery will begin charging.
Maintaining
•
It is parents' responsibility to check main parts of the toy before using, Must regularly
examine for potential hazard, such as the battery, charge,cable or cord, plug, screws are
fastening enclosure of other parts and that in the event of such damage, the toy must
not be until that damage had been properly removed.
• Make sure the plastic parts of the vehicle are not cracked or broken.
• Occasionally use a lightweight oil to lubricate moving parts such as wheels.
• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Keep the vehicle away from sources of heat, such as stoves and heaters. Plastic parts
may melt.
• Recharge the battery after each use. Only an adult can handle the battery. Recharge the
battery at least once a month when the vehicle Raider is not being used.
• Do not wash the vehicle with a hose. Do not wash the vehicle with soap and water. Do
not drive the vehicle in rainy or snowy weather. Water will damage the motor, electric
system and battery.
• Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-wax
furniture polish. Do not use car wax. Do not use abrasive cleaners.
• Do not drive the vehicle in loose dirt, sand or fine gravel which could damage moving
parts, motors or the electric system.
• When not using, all the electrical source should be turn off. Turn off the power switch
and disconnect the battery connection.
Our products are suitable for ASTM F963; GB6675; EN71 and EN62115 standard.
