7. COMMISSIONING INSTRUCTIONS
The commissioning is only permitted to approved personnel.
7.1 Commissioning - Conditions and starting points
Make sure that the necessary moving direction of the operated system agrees with:
•
The control direction of the Automatic Control (ACS)
•
The control direction of the Manual Control (MC).
Obey the procedures that follow:
•
§7.2 Check: Control direction of the Automatic Control (ACS)
•
§7.3 Check: Control direction of the Manual Control (MC).
Refer to the product manual of the used Ridder motor-gearbox at
adjust
the
end
positions!
Do not go across the limits of the system. This prevents damage or
injury.
Before the system is put into operation, the installer must always
make sure that the limit switch is correctly adjusted.
Make sure that there is no blockage of the system before the limit-
switch system is adjusted. This prevents damage or injury.
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
24
Summary of Contents for LogicLink RLL400
Page 32: ......
