Ricoh PJ WX4153, Safety Information Manual

Page: 21 / 24

2. Information for This Machine
This chapter describes laws and regulations related to this machine.
Laws and Regulations
EMC Directive
Using the shield cable
Properly shielded and grounded cables and connectors must be used for connections to a host computer
(and/or peripheral) in order to meet emission limits.
Notes to USA Users of FCC Requirements
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio /TV technician for help.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Properly shielded and grounded cables and connectors must be used for connections to a host computer
(and/or peripheral) in order to meet FCC emission limits.
Supplier's Declaration of Conformity
This device complies with Part 15 of the FCC Rules.
19