English
57
English
Replacing the lamp
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
Lamp is approaching the end of its useful life
Replacement Suggested!
When you see this message, change the lamp as soon as
possible. Make sure the projector has been cooled down for at
least 60 minutes before changing the lamp.
Warning: To avoid
burns, allow the
projector to cool for
at least 60 minutes
before you replace the
lamp!
Warning: To avoid the
risk of personal injury,
do not drop the lamp
module or touch the
glass parts. The glass
parts may shatter and
cause injury if it is
dropped.
Warning: For
continued safety
replace with
PJ Replacement Lamp
Type 26.
Caution: If the lamp
should break, handle
with care to avoid
injury due to broken
pieces and contact your
sales representative for
repair service.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the
“Power”.
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the 2 screws from the cover.
5. Push up and remove the lamp cover.
6. Loosen the 2 screws from the lamp module
and pull up
the lamp bar.
7. Pull out the lamp module by force.
8. Install the new lamp module by reversing the previous steps.
See the lamp’s manual for instructions on resetting the lamp
time.
1
2
4
3
Used Lamps
This projector’s lamp contains trace amounts of environmentally
harmful inorganic mercury. Be careful not to break used lamps,
and dispose of them in accordance with local regulations or
contact your sales representative.
