A roll stopper [B] is put in each end of a roll. The roll lever [C] locks the stoppers in their position after they
are put in the ends of a roll. The roll is put on the rack with each stopper locked in its position.
Roll Paper Cutting Mechanism
Immediately before cutting, the registration roller continues to turn at normal speed, but the roll feed motor
speed increases by a small quantity. This causes the paper to buckle slightly between the registration roller
and the top of the cutter, and this gives the machine time to cut the paper.
The cutter motor below the drive gear [A] switches on and moves the rotary cutter [B] and its handle across
the width of the paper. The switch [C] on the left or right end detects when to stop the cutter motor. The
6. Details
410
6
Summary of Contents for Neptune-P1
