Type 2 Printer: Installing Options
25
2
Type 2 Printer: Installing Options
Type 2 Printer: Installing Paper
Feed Unit Type 1400
Note
❒
See the inside front cover of this
manual to confirm which printer
(Type 1 Printer or Type 2 Printer)
you have.
Important
❒
Do not slide more than one paper
tray out at a time. Having more
than one paper tray filled with pa-
per in a fully extended position
could cause the printer to tilt for-
ward.
❒
To make the printer recognize the
installed option, you should set up
the option with the printer driver.
A
Confirm that the box contains the
following items.
• Paper feed unit (including a
paper tray)
• Installation Guide
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
• The interface cable is un-
plugged from the printer.
• The bypass tray and front cov-
er are closed.
C
At the front of the paper feed unit,
tape on the left and right sides is
used to hold the tray in place. Re-
move both pieces of tape.
D
There are four pins on the top of
the paper feed unit that point
straight up. On the bottom of the
printer, there are four holes.
Align the holes over the pins and
lower the printer gently onto the
paper feed unit.
R
CAUTION:
•
When lifting the printer, use the
inset grips on both sides.
Summary of Contents for Laser AP1600
Page 12: ...x...
Page 46: ...Installing Options 34 2...
