Ricoh Gestetner C7006 SLC6c, Setup Manual

Page: 27 / 70

Installing the Network Interface Board Type306
17
2
Installing the Network Interface Board
Type306
R
CAUTION:
Important
❒
Use a shielded twisted-pair (STP)
network cable.
Note
❒
There are two connectors on the
printer board. You can install the
network interface board in either.
❒
Two network interface boards can-
not be installed at a time.
A
Turn off the printer's power
switch and remove all cables and
cords from the printer.
B
Remove both screws and remove
the printer board from the printer
as shown in the illustration.
Note
❒
A coin can be used to remove
the screws.
C
Remove both screws and the met-
al plate from the printer board.
D
Insert the network interface
board into the slot and fasten it
with both screws that were re-
moved in step
C
, as shown in the
illustration.
• Before installing options, the ma-
chine should be turned off and
unplugged for at least thirty min-
utes. Components inside the
machine become very hot, and
can cause a burn injury if
touched.
ZDGP010J
ZDGP190J
ZDGP200J