6/14
FV-G030B1
Product Specifications Rev. 1.03
2
Electronic / Mechanical / Environmental Specifications
Product
FV-G030B1
Imager
1/3” Interline VGA monochrome progressive CCD: ICX424AL
Total Picture Elements
692 (H) x 504 (V)
Active Picture Elements
VGA: 648 (H) x 494 (V)
Cell Size
7.4 (H) x 7.4 (V) µm
Scanning System
Progressive
Vertical Frequency
(Frame Rate)
89.91172 Hz at full resolution
0.72028 to 360.33325 Hz adjustable via the communication
(Frame rate depends on the AOI setting)
Maximum frame rate (360.33325 Hz) is when vertical resolution AOI setting is 104.
Horizontal Frequency
47.2028 kHz
Pixel Frequency
36.8181 MHz
@ 8bit output
≤ 3 Digit (Gain 0 dB)
@ 10bit output
≤ 12 Digit (Gain 0 dB)
Noise
Level
@ 12bit output
≤ 48 Digit (Gain 0 dB)
Minimum Scene Illumination
0.58 Lux at F1.2, 89.91172 Hz
Sync. System
Internal
Video Output Format
Digital 8, 10 or 12 bit Raw Data
Interface
IEEE802.3 (1000BASE-T)
Protocol
GigE Vision® 1.2 and GenICam™ 2.0 compliant
Exposure Time
Preset continuous mode: 10 useconds to 16,777,215 useconds
Preset trigger mode: 10 useconds to 16,777,215 useconds
Pulse width mode: 10 useconds to Unlimited
ALC
Auto iris lens, electronic iris and AGC (ON/OFF)
Gain
0 to 20.4 dB
Gamma
Gamma 1.0 (Factory default) or uploadable gamma table
AOI Function
Variable AOI setting via the communication
Smear Reduction
Selectable ON/OFF via the communication
Operational Mode
Edge preset trigger, Pulse width trigger (unlimited long exposure)
Communication
UART communication through Ethernet port
I/O
One opt-isolated input and two LVTTL outputs
Auto IRIS Lens Control
DC IRIS control input with video level target, peak/average and zone weight settings
via the communication
Input Voltage
+10.8 to +26.4 Vdc
Electronic
Specifications
Power
Consumption
Less than 5.0
W
Dimensions
35 (W) x 35 (H) x 50.8(D) mm excluding connectors
Optical Filter
No Filter
Optical Center Accuracy
Positional accuracy in H and V directions: +/- 0.3 mm
Rotational accuracy of H and V: +/- 1.5 deg.
Material
Aluminum (AC)
Lens Mount
C mount
Connectors
RJ45 connector
Power-I/O connector: HR10A-7R-6PB (Hirose) or equivalent
DC IRIS lens connector: M1951 (EMUDEN) or equivalent
Mechanical
Specifications
Camera Mount Screws
Two 1/4” Tripod screw holes: (One on each top and bottom plate),
Twelve M4 screws holes: (Four on each top and bottom plate, two on each side plate)
