4. NCU Parameter Programming
To enter this mode, enter the "Change Settings" menu, press Copy four times, then press Start. The entry menu will
be printed.
NCU 0:00001111/0F 1:00110001/31 2:00000001/01 ------------------ 5:00001111/0F
SET NCU PARAMETER : ENTER 3 ADDRESS BITS: COPY=0 START=1
The upper line of the menu shows the current parameter settings.
If you want to change the setting of a parameter, enter the parameter number in three-bit binary code (e.g., press
Copy (0), Copy (0), then Start (1) for NCU parameter 1), then press Start. The selected parameter setting will be
printed.
FOR NCU-1:00110001 ENTER 8 DATA BITS: COPY=0 START=1
Then enter new settings using the Copy and Start keys. (e.g., 01000000 = C-S-C-C-C-C-C-C for 40(H)).
Refer to section 4-2-1 (Address 037D - 0381 (H)) for the NCU parameter definitions.
NCU-1 SET: 01000000 DEFAULT: 00110001
After printing the new settings, the machine returns to the NCU parameter entry menu.
5. Initial Rx Modem Rate Programming
To enter this mode, enter the "Change Settings" menu, press Copy 4 times, then press Start. The following instruc-
tion will be printed.
SET INIT. MODEM RATE - 1:9600 2:4800
Select the required Rx modem rate by pressing Copy one or two times, then press Start.
INIT. MODEM RATE: 9600
Then the machine will return to the "Change Settings" menu.
6. Echo Countermeasure (DIS Detection Times) Programming
To enter this mode, enter the "Change Settings" menu, press Copy five times, then press Start. The following in-
struction will be printed.
SET ECHO COUNTERMEASURE - 1:1X 2:2X
This Select the required setting by pressing Copy once (1x) or twice (2x), then press Start.
ECHO COUNTERMEASURE IS 2X
Then the machine will return to the "Change Settings" menu.
7. Rx Cable Equalizer
To enter this mode, enter the "Change Settings" menu, press Copy six times, then press Start. The following instruc-
tion will be printed.
SET CABLE EQUALIZER - 1: ON 2:OFF
Select the required setting by pressing Copy once, or twice, then press Start.
CABLE EQUALIZER IS ON
Then the machine will return to the "Change Settings" menu.
2-6