Installation 4-2
II
L
00
2) Fasten the Pass Unit to the Stacker with three M5x12 HEX Socket Bolts and washers.
3) Turn all the Jack screws until they just touch to the floor.
4) Turn all the Jack screws again so that there are about 1mm of space between Casters and
floor. (Refer to the drawing of previous page.)
5) Fasten the BS plate Assembly with a screw (M3x6). (Only when connecting the
B
ourg
S
heet
R
otator to the side of the Pass Unit )
M5x12 HEX Socket Bolt
and Washer
Front side of Pass Unit
M5x12 HEX Socket Bolt
and Washer
Rear side of Pass Unit
BS Plate Assembly
Screw (M3x6)
Note. When connecting the BSR to the Pass Unit, insert the BS Plate Assembly between the paper path of the
BSR.
01
BS Plate Assembly
The paper path of the BSR
