X03258 CF5010e Service manual
CF-3-9
3.2.6 DRIVE MOTOR M16 ASSEMBLY
[A]
0.4 ± 0.3 mm play between
the coupling and the clutch
Removal
1. Remove complete Cover Feeder unit (
1.1.1).
2. Disconnect Connector [A] (
x1).
3. Remove Drive motor M16 assembly by removing screws [B] ( x2).
NOTE:
Be careful when removing the Drive motor M16 assembly, so that the
Drive Shaft Assembly will not damage the LED sensor CF-Q30 (
3.1.2).
4. Loosen the allen screw [C] to Drive clutch assembly ( x1).
5. Remove the motor bracket by removing screws [D] ( x3).
[B]
[C]
[D]
Replacement
1. Reverse the removal procedure.
2. Enter Service mode (
5.1.1 in BK5010e Service Manual).
3. Perform Cover Feeder motor calibration (
5.5 in BK5010e Service Manu-
al).
Adjustment
Adjust the Drive clutch assembly, so that there is play between the coupling on the
Drive shaft and the Clutch. The play should be 0.4 ± 0.3 mm. Adjust by loosening
screw [C].
[C]
