Ricoh Aficio FX10, Service Manual

Page: 100 / 284

6.
If the software is successfully uploaded,
the display shows “OK”.
OK!!
COPY MACH -> FLROM
If the software upload fails, the display
shows “NG”.
NG!!
COPY MACH -> FLROM
7. Finish :
8. Turn off the machine and disconnect the tool. Then turn the machine back
on again.
4.1.23. SRAM Data Download (Function 12)
This function copies all the data stored in the SRAM on an external FCU to
the machine’s FCU. Use this after replacing a damaged FCU to save any pre-
vious settings that were programmed in the damaged FCU.
1. Turn off the machine.
2. Connect the Flash/SRAM Copy Tool [A] and the damaged FCU [C] as
shown in section 4.1.20.
Note: The switch [D] on the tool could be either ON or OFF.
3. Turn on the machine.
4.
then immediately
FUNCTION KPAD/NEXT
SERVICE FUNCTIONS
5.
0-SRAM 1-SAF
2-SAFCARD 3-M—>R
6.
7.
If the SRAM data is successfully down-
loaded, the display shows “OK”.
OK!!
COPY MACH <- SRAM
If the SRAM download fails, the display
shows “NG”.
NG!!
COPY MACH <- SRAM
8. Finish :
9. Turn off the machine and disconnect the tool. Then turn the machine back
on.
Ser
v
ic
e T
a
b
les
June 10th, 1997 SERVICE TABLES AND PROCEDURES
SERVICE LEVEL FUNCTIONS
4-15